Stripers247.com Forums - View Single Post - Sealing with Pressure
View Single Post
  #5  
Old 05-21-2014, 07:11 AM
toadfrog's Avatar
toadfrog toadfrog is offline
Striper Hunter
 
Join Date: Jun 2010
Location: OKLAHOMA
Posts: 47
Default Re: Sealing with Pressure

I have got to start paying more attention to this site . I could have helped early on . Sorry guys . Pressure and vacuum go along way to create good products . Along with plugs being pressure treated , Plastics need to be put under vacuum . If you get some plastic that gives you fits with bubbles and dents then it more than likely needs degassed by pulling a vacuum on the raw material . Just an fyi in case you run up against that .
Reply With Quote